Alltrade Powerbuilt 640819 Mechanical Scissor Jack
Alltrade Powerbuilt 640819 Mechanical Scissor Jack
Powerbuilt offers anything you need for heavy lifting in garage or shop. Heavy duty steel frame and saddle. Oversize base for maximum support and stability. Working range: 4 inch to 14 inch.
- UPC: 028907262697
- ASIN: B002INP6QU
- Brand: Alltrade
- Size: 3000 lb, Scissor Jack
- Manufacturer: Alltrade
for Caravans/Dodge/Honda Jazz/Audi/BMW/Benz/Ford/Chevrolet 2 Ton 2 Tonne Scissor Jack 105mm to 385mm Wind Up Jack Chromed Crank with Speed Handle - 2 Year Warranty
for Caravans/Dodge/Honda Jazz/Audi/BMW/Benz/Ford/Chevrolet 2 Ton 2 Tonne Scissor Jack 105mm to 385mm Wind Up Jack Chromed Crank with Speed Handle - 2 Year Warranty
The scissor jack, with tooth gears, can extend from 90mm(close position) to 360mm, more than enough to lift most vehicles. Scope: Suitable for small and medium sized vehicles. Such as: cars, Buick, Santana, Vietnam and other vehicles. WARNING 1. Study, understand and follow all instructions before operating this device. 2. Do not exceed rated capacity as designated by the height/capacity curve.(Sea below) 3. Use only on hard level surface. 4. Use for emergency tire changing only. 5. Never get beneath the vehicle when it is supported by the jack. 6. Activate the hazard warning flasher,turn off ignition, set parking brake, move automatic shift selector to park position. In case of a manual transmission, move gear selector into reverse position. In addition, the wheel diagonally opposite from the wheel being lifted shall be chocked in both directions. 7. Lift only on areas of the vehicle as specified by the vehicle manufacturer. 8. Follow tire changing procedure as per the vehicle manufacturer's owner's manual. 9. No alterations shall be made to this product. 10. Failure to heed these messages may result in personal injury and/or property damage. HEIGHT/CAPACITY CURVE This device is designed to sustain the following loads at these specified heights. DO NOT EXCEED the rated capacity for each position. Before Use 1. Check before each use for abnormal conditions such as cracked welds, leaks, damaged, loose or missing parts. 2. Inspect the jack immediately if lift is believed to have been subjected to an abnormal load or shock. 3. If the jack is found to be damaged, it should be removed from service until properly repaired.
- UPC: 783057877671
- ASIN: B073PW19N3
- Brand: Autobaba
- Manufacturer: Autobaba
LEAD BRAND Scissor Jack 1.5 Tons(3,307 lbs) Capacity Saving Strength Design VA004
LEAD BRAND Scissor Jack 1.5 Tons(3,307 lbs) Capacity Saving Strength Design VA004
The Lead Brand scissor jack is 1.5 Tons (about 3,307 lbs) .It can be used when you need to repair the tire.The compact size and small volume can be easily to preserve.The raise of maximum height is 385mm(15.16") and it suits for most sedans.Collocating with wrench can lift the car easily.The thickness of steel is 3.1mm(0.12") and the net weight is 2.76kg(6.08 lbs) .After testing the plant summed that the scissor jack can lift the car which is 1.5 Tons(3,307 lbs).The utmost is 1.6 Tons(3,527 lbs).Comparing with hydraulic jack, the scissor jack is conveniently and easily to operate.The product highlight is our saving strength design,it can let you feel easy to operate the scissors jack.Usage Method: 1. Fasten the rest three tires using pads or bricks 2. Turn the jack by hand until the jack elevate the vehicle botton. 3. Put the ratchet wrench into the jack, and then turn the wrench. After that we can elevate the jack. 4.Adding engine oil (not included) into screw of Jack, it can make the screw rotation more smoothly, and reduce the jack noise.
- ASIN: B07CZGTXYH
- Brand: LEAD BRAND
- Manufacturer: LEAD BRAND
LEAD BRAND Scissor Jack 2 Tons(4,409 lbs) Capacity Saving Strength Design with Ratchet Handle
LEAD BRAND Scissor Jack 2 Tons(4,409 lbs) Capacity Saving Strength Design with Ratchet Handle
The Lead Brand scissor jack is 2 Tons (about 4,409 lbs) .It can be used when you need to repair the tire. The compact size and small volume can be easily to preserve.The raise of maximum height is 442mm(17.4") and it suits for most sedans. Collocating with wrench can lift the car easily. The thickness of steel is 3.1mm(0.12") and the net weight is 3.62kg(7.98 lbs) .After testing the plant summed that the scissor jack can lift the car which is 2 Tons(4,409 lbs).The utmost is 2.2 Tons(4,850 lbs) for multiple vehicle.Comparing with hydraulic jack, the scissor jack is conveniently and easily to operate.The product highlight is our saving strength design,it can let you feel easy to operate the scissors jack.Usage Method: 1. Fasten the rest three tires using pads or bricks 2. Turn the jack by hand until the jack elevate the vehicle botton. 3. Put the ratchet wrench into the jack, and then turn the wrench. After that we can elevate the jack. 4.Adding engine oil (not included) into screw of Jack, it can make the screw rotation more smoothly, and reduce the jack noise.
- ASIN: B07CZGK5J6
- Brand: LEAD BRAND
- Manufacturer: LEAD BRAND
Autofu Universal Scissor Jack 2 Ton Wind Up Lift Floor Jacks 14 Inch Height with Crank Speed Handle Rust-Proof for Ford F-150 Chevrolet Toyota Dodge Ram
Autofu Universal Scissor Jack 2 Ton Wind Up Lift Floor Jacks 14 Inch Height with Crank Speed Handle Rust-Proof for Ford F-150 Chevrolet Toyota Dodge Ram
The scissor jack, with tooth gears, can extend from 90mm(close position) to 360mm, more than enough to lift most vehicles. Easy to operate using the chromed crank with speed handle. Condition: Brand new Minimum height: about 90MM Maximum height: approximately 360MM Lifting: 2.0T Material: Steel Net weight: 2.1KG Item Size: 35*8.5*8.5 (L×W×T) Scope: Suitable for small and medium sized vehicles. Such as: For cars/Buick/Santana/Vietnam and other vehicles. Packing include: Scissor jack * 1 Handle * 1 HEIGHT/CAPACITY CURVE This device is designed to sustain the following loads at these specified heights. DO NOT EXCEED the rated capacity for each position. Before Use: 1. Check before each use for abnormal conditions such as cracked welds, leaks, damaged, loose or missing parts. 2. Inspect the jack immediately if lift is believed to have been subjected to an abnormal load or shock. 3. If the jack is found to be damaged, it should be removed from service until properly repaired. OPERATING INSTRUCTIONS 1. Insert the jack handle into the hole of the handle socket. 2. Make sure that the saddle is correctly positioned. To prevent damage to the jack, do not move the jack while the handle is intact in the socket. 3. To raise load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle clockwise. 4. To lower load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle counterclockwise slowly. CARE AND MAINTENANCE: 1. When jack is not in use, lifting arm should be in full down position. 2. Always keep jack clean and keep the screw and bearings well lubricated. 3. Store the handle with care.
- UPC: 667673316120
- ASIN: B06ZY83PLD
- Brand: Autofu
- Size: Scissor Jack
- Manufacturer: Autofu
DICN Universal Spare Tire Tool Kit Wheel Lug Nut Wrench 17mm 19mm 21mm 23mm + Scissor Jack 2 Ton for Car Van Road Side Emergency
DICN Universal Spare Tire Tool Kit Wheel Lug Nut Wrench 17mm 19mm 21mm 23mm + Scissor Jack 2 Ton for Car Van Road Side Emergency
Packing includes: 1x Extendible Telescopic Wrench 2x Double Ended Chrome Vanadium Socket 1x Scissor jack(with handle) Wrench: High-torque telescopic extending car wheel nut wrench easily undoes wheel nuts High torque extending handle for easy use and extra leverage power Strong, light and compact construction Fitted with durable toughened non-slip rubber handle for extra grip and comfort Made of chrome carbon steel Supplied with 2 Double ended sockets (17/19MM) (21/23MM) Chrome Vanadium sockets Telescopic extending handle extends from 350MM to 550MM Scissor Jack: Color: Black Minimum height: about 105MM Maximum height: approximately 385MM Lifting: 2.0T Color: Black Material: Steel Net weight: 2.1KG Item Size: 41*8.8*9 (L×W×T) Included: Chromed Crank Speed Handle
- UPC: 783057999762
- ASIN: B073S4YWJT
- Brand: DICN
- Manufacturer: DICN Factory
Torin Big Red Steel Scissor Jack, 1.5 Ton (3,000 lb) Capacity
Torin Big Red Steel Scissor Jack, 1.5 Ton (3,000 lb) Capacity
The Torin Big Red steel scissor jack is 1-1/2 Tons (3,000 lbs) and can be used as a rugged replacement jack or an extra utility jack that can be stored in the trunk of your car due to its compact size. The jack has a lift range from 4-1/8" to 15-1/8" with an oversized base width of 4-1/2" that provides maximum support. This extra-wide base offers easy positioning and the folding handle delivers on-the-spot quick response and speed when you need it. Features a rugged alloyed steel construction with heavy-duty steel frame and saddle. The unit is factory tested for reliability to meet ASME standards and includes a limited 1 year manufacturer warranty.
- UPC: 615268101521
- ASIN: B004PX8BC2
- Brand: Torin
- Manufacturer: Torin
DICN Vehicle Scissor Jack 2 Ton/15 Inch Black Steel with Crank Handle for Toyota Ford BMW Mazda
DICN Vehicle Scissor Jack 2 Ton/15 Inch Black Steel with Crank Handle for Toyota Ford BMW Mazda
Package included: Scissor jack x 1 Handle x 1 Specification: Condition: Brand new Minimum height: about 105MM Maximum height: approximately 385MM Lifting: 2T Color: Black Material: Steel Net weight: 2.1KG Item Size: 41*8.8*9CM HEIGHT/CAPACITY CURVE This device is designed to sustain the following loads at these specified heights. DO NOT EXCEED the rated capacity for each position. Before Use 1. Check before each use for abnormal conditions such as cracked welds, leaks, damaged, loose or missing parts. 2. Inspect the jack immediately if lift is believed to have been subjected to an abnormal load or shock. 3. If the jack is found to be damaged, it should be removed from service until properly repaired. OPERATING INSTRUCTIONS 1. Insert the jack handle into the hole of the handle socket. 2. Make sure that the saddle is correctly positioned. To prevent damage to the jack, do not move the jack while the handle is intact in the socket. 3. To raise load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle clockwise. 4. To lower load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle counterclockwise slowly. CARE AND MAINTENANCE 1. When jack is not in use, lifting arm should be in full down position. 2. Always keep jack clean and keep the screw and bearings well lubricated. 3. Store the handle with care.
- UPC: 783057985888
- ASIN: B073J3X67C
- Brand: DICN
- Size: Scissor Jack
- Manufacturer: DICN Factory
Auto Accessories Dealer 2 Pack Universal for BMW and Mini Square Polyurethane Jack Pad Adapter by TMB
Auto Accessories Dealer 2 Pack Universal for BMW and Mini Square Polyurethane Jack Pad Adapter by TMB
OEM BMW rubber jack points are prone to collapse and bending when using standard jacks. These jack pad adapters will properly fill the square slot on all BMWs and prevent from crushing/collapsing your OEM jack points. Please exercise proper safety precautions when lifting your vehicle
- ASIN: B00XK4NZMS
- Brand: Auto Accessories Dealer
- Manufacturer: Auto Accessories Dealer
Performance Tool W1600 1-1/2 Ton (3,000lb) Capacity Scissor Jack, 4" - 15" Lift Range
Performance Tool W1600 1-1/2 Ton (3,000lb) Capacity Scissor Jack, 4" - 15" Lift Range
The Wilmar W1600 1-1/2 Ton Scissor Jack has a 3,000-Pound load capacity and a lift range from 4 to 15-Inch. Its oversized base adds stability and support and has sturdy steel construction and precision threaded sha-Feet Its compact size will fit in trunk or truck.
- UPC: 039564016004
- ASIN: B005LPU3B0
- Brand: Performance Tool
- Size: Manual Scissor Jack
- Manufacturer: Wilmar Corporation